The Juniper perimeter router must be configured to protect an enclave connected to an alternate gateway by using an inbound filter that only permits packets with destination addresses within the site's address space.
An XCCDF Rule
Description
<VulnDiscussion>Enclaves with alternate gateway connections must take additional steps to ensure there is no compromise on the enclave network or NIPRNet. Without verifying the destination address of traffic coming from the site's alternate gateway, the perimeter router could be routing transit data from the internet into the NIPRNet. This could also make the perimeter router vulnerable to a denial-of-service (DoS) attack as well as provide a back door into the NIPRNet. The DoD enclave must ensure the ingress filter applied to external interfaces on a perimeter router connecting to an Approved Gateway is secure through filters permitting packets with a destination address belonging to the DoD enclave's address block.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>
- ID
- SV-253989r844000_rule
- Severity
- High
- References
- Updated
Remediation - Manual Procedure
This requirement is not applicable for the DODIN Backbone.
Configure the ingress filter of the perimeter router connected to an alternate gateway to only permit packets with destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the alternate gateway network service provider. For example:
set policy-options prefix-list inside_addresses-ipv4 <IPv4 subnet / mask>
set policy-options prefix-list inside_addresses-ipv6 <IPv6 subnet / prefix>