Skip to content

Riverbed Optimization System (RiOS) must protect against or limit the effects of all known types of Denial of Service (DoS) attacks on the network device management network by employing organization-defined security safeguards.

An XCCDF Rule

Description

<VulnDiscussion>DoS is a condition when a resource is not available for legitimate users. When this occurs, the organization either cannot accomplish its mission or must operate at degraded capacity. This requirement addresses the configuration of network devices to mitigate the impact of DoS attacks that have occurred or are ongoing on device availability. For each network device, known and potential DoS attacks must be identified and solutions for each type implemented. A variety of technologies exist to limit or, in some cases, eliminate the effects of DoS attacks (e.g., limiting processes or restricting the number of sessions the device opens at one time). Employing increased capacity and bandwidth, combined with service redundancy, may reduce the susceptibility to some DoS attacks. The security safeguards cannot be defined at the DoD level because they vary according to the capabilities of the individual network devices and the security controls applied on the adjacent networks (for example, firewalls performing packet filtering to block DoS attacks).</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>

ID
SV-77481r1_rule
Severity
Medium
References
Updated



Remediation - Manual Procedure

Configure RiOS to protect against or limit the effects of all known types of Denial of Service (DoS) attacks on the network device management network.

Navigate to the device Management Console
Navigate to Configure >> Security >> Management ACL
Click "Add a New Rule"
Set "Action" to "Allow"