The Juniper PE router must be configured with Unicast Reverse Path Forwarding (uRPF) loose mode enabled on all CE-facing interfaces.
An XCCDF Rule
Description
<VulnDiscussion>The uRPF feature is a defense against spoofing and denial-of-service (DoS) attacks by verifying if the source address of any ingress packet is reachable. To mitigate attacks that rely on forged source addresses, all provider edge routers must enable uRPF loose mode to guarantee that all packets received from a CE router contain source addresses that are in the route table.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>
- ID
- SV-217077r604135_rule
- Severity
- Medium
- References
- Updated
Remediation - Manual Procedure
Configure uRPF loose mode on all CE-facing interfaces as shown in the example.
[edit interfaces ge-0/1/0 unit 0 family inet]
set rpf-check mode loose