Access to virtual machines (VMs) through the "dvfilter" network Application Programming Interface (API) must be controlled.

An XCCDF Rule

Description

An attacker might compromise a VM by using the "dvFilter" API. Configure only VMs that need this access to use the API.

ID: SV-256467r959010_rule
Version: VMCH-70-000019
Severity: Low
References: CCI-000366
Updated: about 2 months ago

Remediation Templates

From the vSphere Client, right-click the Virtual Machine and go to Edit Settings >> VM Options >> Advanced >> Configuration Parameters >> Edit Configuration.

Look for settings with the format "ethernet*.filter*.name".

Ensure only required VMs use this setting.
Note: The VM must be powered off to configure the advanced settings through the vSphere Client. Therefore, it is recommended to configure these settings with PowerCLI as this can be done while the VM is powered on. Settings do not take effect via either method until the virtual machine is cold started, not rebooted.

or

From a PowerCLI command prompt while connected to the ESXi host or vCenter server, run the following command:

Get-VM "VM Name" | Get-AdvancedSetting -Name ethernetX.filterY.name | Remove-AdvancedSetting

Note: Change the X and Y values to match the specific setting in the organization's environment.

Access to virtual machines (VMs) through the "dvfilter" network Application Programming Interface (API) must be controlled.

Description

Remediation Templates

A Manual Procedure