The ESXi Image Profile and vSphere Installation Bundle (VIB) acceptance level must be verified.

An XCCDF Rule

Description

Verify the ESXi Image Profile to only allow signed VIBs. An unsigned VIB represents untested code installed on an ESXi host. The ESXi Image profile supports four acceptance levels: 1. VMwareCertified - VIBs created, tested, and signed by VMware. 2. VMwareAccepted - VIBs created by a VMware partner but tested and signed by VMware. 3. PartnerSupported - VIBs created, tested, and signed by a certified VMware partner. 4. CommunitySupported - VIBs that have not been tested by VMware or a VMware partner. Community Supported VIBs are not supported and do not have a digital signature. To protect the security and integrity of ESXi hosts, do not allow unsigned (CommunitySupported) VIBs to be installed on hosts. Satisfies: SRG-OS-000366-VMM-001430, SRG-OS-000370-VMM-001460

ID: SV-258746r1015923_rule
Version: ESXI-80-000133
Severity: High
References: CCI-001749 CCI-001774 CCI-003992
Updated: about 2 months ago

Remediation Templates

From the vSphere Client, go to Hosts and Clusters.

Select the ESXi Host >> Configure >> System >> Security Profile.

Under "Host Image Profile Acceptance Level", click "Edit".
Using the drop-down selection, set the acceptance level as "VMwareCertified", "VMwareAccepted", or "PartnerSupported". The default is "PartnerSupported".

or

From a PowerCLI command prompt while connected to the ESXi host, run the following commands:

$esxcli = Get-EsxCli -v2
$arguments = $esxcli.software.acceptance.set.CreateArgs()
$arguments.level = "PartnerSupported"
$esxcli.software.acceptance.set.Invoke($arguments)

Note: "VMwareCertified" or "VMwareAccepted" may be substituted for "PartnerSupported", depending on local requirements. These are case sensitive.

The ESXi Image Profile and vSphere Installation Bundle (VIB) acceptance level must be verified.

Description

Remediation Templates

A Manual Procedure