The vCenter Server must configure the vSAN Datastore name to a unique name.

An XCCDF Rule

Description

<VulnDiscussion>A vSAN Datastore name by default is "vsanDatastore". If more than one vSAN cluster is present in vCenter, both datastores will have the same name by default, potentially leading to confusion and manually misplaced workloads.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>

ID: SV-258949r934505_rule
Severity: Medium
References: CCI-000366
Updated: 17 days ago

From the vSphere Client, go to Host and Clusters.

Select a vSAN Enabled Cluster >> Datastores.

Right-click on the datastore named "vsanDatastore" and select "Rename".
Rename the datastore based on site-specific naming standards.

Click "OK".

or

From a PowerCLI command prompt while connected to the vCenter server, run the following commands:

If($(Get-Cluster | where {$_.VsanEnabled} | Measure).Count -gt 0){
Write-Host "vSAN Enabled Cluster found"
$Clusters = Get-Cluster | where {$_.VsanEnabled} 
Foreach ($clus in $clusters){
 $clus | Get-Datastore | where {$_.type -match "vsan"} | Set-Datastore -Name $(($clus.name) + "_vSAN_Datastore")
}
}
else{
Write-Host "vSAN is not enabled, this finding is not applicable."
}

The vCenter Server must configure the vSAN Datastore name to a unique name.

Description

Remediation - Manual Procedure