The Juniper MPLS router must be configured to use its loopback address as the source address for LDP peering sessions.
An XCCDF Rule
Description
<VulnDiscussion>Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of backbone routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of from a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router's loopback address instead of the numerous physical interface addresses.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>
- ID
- SV-217063r992002_rule
- Severity
- Low
- References
- Updated
Remediation - Manual Procedure
Configure the router to use their loopback address as the source address for LDP peering sessions. As noted in the check content, the default behavior is to use its loopback address. However, if a router ID is configured, ensure it matches the address of the loopback address as shown in the example below.
[edit routing-options]
set router-id 2.2.2.2