Skip to content

Forescout must be configured to synchronize internal information system clocks using redundant authoritative time sources.

An XCCDF Rule

Description

<VulnDiscussion>The loss of connectivity to a particular authoritative time source will result in the loss of time synchronization (free-run mode) and increasingly inaccurate time stamps on audit events and other functions. Multiple time sources provide redundancy by including a secondary source. Time synchronization is usually a hierarchy; clients synchronize time to a local source while the source synchronizes time to a more accurate source. The network device must utilize an authoritative time server and/or be configured to use redundant authoritative time sources. This requirement is related to the comparison done in CCI-001891. DOD-approved solutions consist of a combination of a primary and secondary time source using a combination or multiple instances of the following: a time server designated for the appropriate DOD network (NIPRNet/SIPRNet); United States Naval Observatory (USNO) time servers; and/or the Global Positioning System (GPS). The secondary time source must be located in a different geographic region than the primary time source.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>

ID
SV-230944r1018752_rule
Severity
Medium
References
Updated



Remediation - Manual Procedure

Configure Forescout to synchronize internal information system clocks with the primary and secondary time sources located in different geographic regions using redundant authoritative time sources.

1. Open an SSH session and authenticate to the Forescout command line.
2. Configure the primary and secondary NTP servers with the command "fstool ntp setup <ip address>".