The Cisco PE switch providing MPLS Layer 2 Virtual Private Network (L2VPN) services must be configured to authenticate targeted Label Distribution Protocol (LDP) sessions used to exchange virtual circuit (VC) information using a FIPS-approved message authentication code algorithm.
An XCCDF Rule
Description
<VulnDiscussion>LDP provides the signaling required for setting up and tearing down pseudowires (virtual circuits used to transport Layer 2 frames) across an MPLS IP core network. Using a targeted LDP session, each PE switch advertises a virtual circuit label mapping that is used as part of the label stack imposed on the frames by the ingress PE switch during packet forwarding. Authentication provides protection against spoofed TCP segments that can be introduced into the LDP sessions.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>
- ID
- SV-221120r999729_rule
- Severity
- Medium
- References
- Updated
Remediation - Manual Procedure
The severity level can be downgraded to a category 3 if the switch is configured to authenticate targeted LDP sessions using MD5 as shown in the example below:
Step 1: Configure a key chain for LDP sessions.
SW1(config)# key chain LDP_KEY
SW1(config-keychain)# key 1