The vCenter Server must disable the distributed virtual switch health check.

An XCCDF Rule

Description

<VulnDiscussion>Network health check is disabled by default. Once enabled, the health check packets contain information on host#, vds#, and port#, which an attacker would find useful. It is recommended that network health check be used for troubleshooting and turned off when troubleshooting is finished.</VulnDiscussion><FalsePositives></FalsePositives><FalseNegatives></FalseNegatives><Documentable>false</Documentable><Mitigations></Mitigations><SeverityOverrideGuidance></SeverityOverrideGuidance><PotentialImpacts></PotentialImpacts><ThirdPartyTools></ThirdPartyTools><MitigationControl></MitigationControl><Responsibility></Responsibility><IAControls></IAControls>

ID: SV-258934r934460_rule
Severity: Medium
References: CCI-000366
Updated: 8 months ago

From the vSphere Client, go to "Networking".

Select a distributed switch >> Configure >> Settings >> Health Check.

Click "Edit".
Disable the "VLAN and MTU" and "Teaming and failover" checks.

Click "OK".

or

From a PowerCLI command prompt while connected to the vCenter server, run the following command:

Get-View -ViewType DistributedVirtualSwitch | ?{($_.config.HealthCheckConfig | ?{$_.enable -notmatch "False"})}| %{$_.UpdateDVSHealthCheckConfig(@((New-Object Vmware.Vim.VMwareDVSVlanMtuHealthCheckConfig -property @{enable=0}),(New-Object Vmware.Vim.VMwareDVSTeamingHealthCheckConfig -property @{enable=0})))}

The vCenter Server must disable the distributed virtual switch health check.

Description

Remediation - Manual Procedure