Skip to content
Log In

C2S for Red Hat Enterprise Linux 7

Rules and Groups employed by this XCCDF Profile

  • Disable Samba

    The smb service can be disabled with the following command: 
    $ sudo systemctl mask --now smb.service
    Rule Low Severity
    Show

  • SNMP Server

    The Simple Network Management Protocol allows administrators to monitor the state of network devices, including computers. Older versions of SNMP were well-known for weak security, such as plaintex...
    Group
    Show

  • Disable SNMP Server if Possible

    The system includes an SNMP daemon that allows for its remote monitoring, though it not installed by default. If it was installed and activated but is not needed, the software should be disabled an...
    Group
    Show

  • Disable snmpd Service

    The snmpd service can be disabled with the following command: 
    $ sudo systemctl mask --now snmpd.service
    Rule Low Severity
    Show

  • SSH Server

    The SSH protocol is recommended for remote login and remote file transfer. SSH provides confidentiality and integrity for data exchanged between two systems, as well as server authentication, throu...
    Group
    Show

  • Verify Group Who Owns SSH Server config file

    To properly set the group owner of /etc/ssh/sshd_config, run the command: 
    $ sudo chgrp root /etc/ssh/sshd_config
    Rule Medium Severity
    Show

  • Verify Owner on SSH Server config file

    To properly set the owner of /etc/ssh/sshd_config, run the command: 
    $ sudo chown root /etc/ssh/sshd_config
    Rule Medium Severity
    Show

  • Verify Permissions on SSH Server config file

    To properly set the permissions of /etc/ssh/sshd_config, run the command: 
    $ sudo chmod 0600 /etc/ssh/sshd_config
    Rule Medium Severity
    Show

  • Configure OpenSSH Server if Necessary

    If the system needs to act as an SSH server, then certain changes should be made to the OpenSSH daemon configuration file <code>/etc/ssh/sshd_config</code>. The following recommendations can be app...
    Group
    Show

  • Set SSH Client Alive Count Max to zero

    The SSH server sends at most <code>ClientAliveCountMax</code> messages during a SSH session and waits for a response from the SSH client. The option <code>ClientAliveInterval</code> configures time...
    Rule Medium Severity
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules