III - Administrative Sensitive
Rules and Groups employed by this XCCDF Profile
-
SRG-NET-000193-RTR-000002
Group -
The Cisco PE switch providing Virtual Private LAN Services (VPLS) must be configured to have traffic storm control thresholds on CE-facing interfaces.
A traffic storm occurs when packets flood a VPLS bridge, creating excessive traffic and degrading network performance. Traffic storm control prevents VPLS bridge disruption by suppressing traffic w...Rule Medium Severity -
SRG-NET-000362-RTR-000119
Group -
The Cisco PE switch must be configured to implement Internet Group Management Protocol (IGMP) or Multicast Listener Discovery (MLD) snooping for each Virtual Private LAN Services (VPLS) bridge domain.
IGMP snooping provides a way to constrain multicast traffic at Layer 2. By monitoring the IGMP membership reports sent by hosts within the bridge domain, the snooping application can set up Layer 2...Rule Low Severity -
SRG-NET-000192-RTR-000002
Group -
The Cisco PE switch must be configured to limit the number of MAC addresses it can learn for each Virtual Private LAN Services (VPLS) bridge domain.
VPLS defines an architecture that delivers Ethernet multipoint services over an MPLS network. Customer Layer 2 frames are forwarded across the MPLS core via pseudowires using IEEE 802.1q Ethernet b...Rule Medium Severity -
SRG-NET-000205-RTR-000007
Group -
The Cisco PE switch must be configured to block any traffic that is destined to the IP core infrastructure.
IP/MPLS networks providing VPN and transit services must provide, at the least, the same level of protection against denial-of-service (DoS) attacks and intrusions as Layer 2 networks. Although the...Rule High Severity -
SRG-NET-000205-RTR-000008
Group -
The Cisco PE switch must be configured with Unicast Reverse Path Forwarding (uRPF) loose mode enabled on all CE-facing interfaces.
The uRPF feature is a defense against spoofing and denial-of-service (DoS) attacks by verifying if the source address of any ingress packet is reachable. To mitigate attacks that rely on forged sou...Rule Medium Severity -
SRG-NET-000205-RTR-000016
Group -
The Cisco PE switch must be configured to ignore or drop all packets with any IP options.
Packets with IP options are not fast-switched and therefore must be punted to the switch processor. Hackers who initiate denial-of-service (DoS) attacks on switches commonly send large streams of p...Rule Medium Severity -
SRG-NET-000193-RTR-000113
Group -
The Cisco PE switch must be configured to enforce a Quality-of-Service (QoS) policy to provide preferred treatment for mission-critical applications.
Different applications have unique requirements and toleration levels for delay, jitter, bandwidth, packet loss, and availability. To manage the multitude of applications and services, a network re...Rule Low Severity -
SRG-NET-000193-RTR-000114
Group -
The Cisco P switch must be configured to enforce a Quality-of-Service (QoS) policy to provide preferred treatment for mission-critical applications.
Different applications have unique requirements and toleration levels for delay, jitter, bandwidth, packet loss, and availability. To manage the multitude of applications and services, a network re...Rule Low Severity -
SRG-NET-000193-RTR-000112
Group -
The Cisco switch must be configured to enforce a Quality-of-Service (QoS) policy to limit the effects of packet flooding denial-of-service (DoS) attacks.
DoS is a condition when a resource is not available for legitimate users. Packet flooding distributed denial-of-service (DDoS) attacks are referred to as volumetric attacks and have the objective o...Rule Medium Severity -
SRG-NET-000019-RTR-000003
Group -
The Cisco multicast switch must be configured to disable Protocol Independent Multicast (PIM) on all interfaces that are not required to support multicast routing.
If multicast traffic is forwarded beyond the intended boundary, it is possible that it can be intercepted by unauthorized or unintended personnel. Limiting where, within the network, a given multic...Rule Medium Severity -
SRG-NET-000019-RTR-000004
Group -
The Cisco multicast switch must be configured to bind a Protocol Independent Multicast (PIM) neighbor filter to interfaces that have PIM enabled.
PIM is a routing protocol used to build multicast distribution trees for forwarding multicast traffic across the network infrastructure. PIM traffic must be limited to only known PIM neighbors by c...Rule Medium Severity -
SRG-NET-000019-RTR-000005
Group -
The Cisco multicast edge switch must be configured to establish boundaries for administratively scoped multicast traffic.
If multicast traffic is forwarded beyond the intended boundary, it is possible that it can be intercepted by unauthorized or unintended personnel. Administrative scoped multicast addresses are loc...Rule Low Severity -
SRG-NET-000362-RTR-000120
Group -
The Cisco multicast Rendezvous Point (RP) switch must be configured to limit the multicast forwarding cache so that its resources are not saturated by managing an overwhelming number of Protocol Independent Multicast (PIM) and Multicast Source Discovery Protocol (MSDP) source-active entries.
MSDP peering between networks enables sharing of multicast source information. Enclaves with an existing multicast topology using PIM-SM can configure their RP switches to peer with MSDP switches. ...Rule Low Severity -
SRG-NET-000019-RTR-000013
Group -
The Cisco multicast Rendezvous Point (RP) switch must be configured to filter Protocol Independent Multicast (PIM) Register messages received from the Designated switch (DR) for any undesirable multicast groups and sources.
Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial...Rule Low Severity -
SRG-NET-000019-RTR-000014
Group -
The Cisco multicast Rendezvous Point (RP) switch must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the Designated Cisco switch (DR) for any undesirable multicast groups.
Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial...Rule Low Severity -
SRG-NET-000364-RTR-000114
Group -
The Cisco multicast Designated switch (DR) must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join only multicast groups that have been approved by the organization.
Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., someone doing a file download here or there), whereas multicast can have b...Rule Low Severity -
SRG-NET-000364-RTR-000115
Group -
The Cisco multicast Designated switch (DR) must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join a multicast group only from sources that have been approved by the organization.
Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., someone doing a file download here or there), whereas multicast can have b...Rule Medium Severity -
SRG-NET-000362-RTR-000122
Group -
The Cisco multicast Designated switch (DR) must be configured to limit the number of mroute states resulting from Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Host Membership Reports.
The current multicast paradigm can let any host join any multicast group at any time by sending an IGMP or MLD membership report to the DR. In a Protocol Independent Multicast (PIM) Sparse Mode net...Rule Medium Severity -
SRG-NET-000362-RTR-000123
Group -
The Cisco multicast Designated switch (DR) must be configured to set the shortest-path tree (SPT) threshold to infinity to minimalize source-group (S, G) state within the multicast topology where Any Source Multicast (ASM) is deployed.
ASM can have many sources for the same groups (many-to-many). For many receivers, the path via the RP may not be ideal compared with the shortest path from the source to the receiver. By default, t...Rule Medium Severity -
SRG-NET-000364-RTR-000116
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to only accept MSDP packets from known MSDP peers.
MSDP peering with customer network switches presents additional risks to the DISN Core, whether from a rogue or misconfigured MSDP-enabled switch. To guard against an attack from malicious MSDP tra...Rule Medium Severity -
SRG-NET-000343-RTR-000002
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to authenticate all received MSDP packets.
MSDP peering with customer network switches presents additional risks to the core, whether from a rogue or misconfigured MSDP-enabled switch. MSDP password authentication is used to validate each s...Rule Medium Severity -
SRG-NET-000018-RTR-000007
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to filter received source-active multicast advertisements for any undesirable multicast groups and sources.
The interoperability of BGP extensions for interdomain multicast routing and MSDP enables seamless connectivity of multicast domains between autonomous systems. MP-BGP advertises the unicast prefix...Rule Low Severity -
SRG-NET-000018-RTR-000008
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to filter source-active multicast advertisements to external MSDP peers to avoid global visibility of local-only multicast sources and groups.
To avoid global visibility of local information, there are a number of source-group (S, G) states in a PIM-SM domain that must not be leaked to another domain, such as multicast sources with privat...Rule Low Severity -
SRG-NET-000018-RTR-000009
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to limit the amount of source-active messages it accepts on a per-peer basis.
To reduce any risk of a denial-of-service (DoS) attack from a rogue or misconfigured MSDP switch, the switch must be configured to limit the number of source-active messages it accepts from each peer.Rule Low Severity -
SRG-NET-000512-RTR-000011
Group -
The Cisco Multicast Source Discovery Protocol (MSDP) switch must be configured to use a loopback address as the source address when originating MSDP traffic.
Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of MSDP switches. It is easier to construct appropriate ingress filters f...Rule Low Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.