Skip to content
ATO Pathways
  Log In

III - Administrative Classified

Rules and Groups employed by this XCCDF Profile

  • SRG-NET-000205-RTR-000004

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to filter ingress traffic at the external interface on an inbound direction.

    &lt;VulnDiscussion&gt;Access lists are used to separate data traffic into that which it will route (permitted packets) and that which it will not r...
    Rule Medium Severity
    Show

  • SRG-NET-000205-RTR-000005

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to filter egress traffic at the internal interface on an inbound direction.

    &lt;VulnDiscussion&gt;Access lists are used to separate data traffic into that which it will route (permitted packets) and that which it will not r...
    Rule Medium Severity
    Show

  • SRG-NET-000205-RTR-000015

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to block all packets with any IP options.

    &lt;VulnDiscussion&gt;Packets with IP options are not fast switched and henceforth must be punted to the switch processor. Hackers who initiate den...
    Rule Medium Severity
    Show

  • SRG-NET-000364-RTR-000111

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to have Link Layer Discovery Protocol (LLDP) disabled on all external interfaces.

    &lt;VulnDiscussion&gt;LLDP is a neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. ...
    Rule Low Severity
    Show

  • SRG-NET-000364-RTR-000111

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to have Cisco Discovery Protocol (CDP) disabled on all external interfaces.

    &lt;VulnDiscussion&gt;CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and ...
    Rule Low Severity
    Show

  • SRG-NET-000364-RTR-000112

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to have Proxy ARP disabled on all external interfaces.

    &lt;VulnDiscussion&gt;When Proxy ARP is enabled on a switch, it allows that switch to extend the network (at Layer 2) across multiple interfaces (L...
    Rule Medium Severity
    Show

  • SRG-NET-000364-RTR-000113

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco perimeter switch must be configured to block all outbound management traffic.

    &lt;VulnDiscussion&gt;For in-band management, the management network must have its own subnet in order to enforce control and access boundaries pro...
    Rule Medium Severity
    Show

  • SRG-NET-000205-RTR-000012

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco switch must be configured to only permit management traffic that ingresses and egresses the out-of-band management (OOBM) interface.

    &lt;VulnDiscussion&gt;The OOBM access switch will connect to the management interface of the managed network elements. The management interface can...
    Rule Medium Severity
    Show

  • SRG-NET-000362-RTR-000124

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco BGP switch must be configured to check whether a single-hop eBGP peer is directly connected.

    &lt;VulnDiscussion&gt;As described in RFC 3682, GTSM is designed to protect a switch's IP-based control plane from DoS attacks. Many attacks focuse...
    Rule Low Severity
    Show

  • SRG-NET-000230-RTR-000002

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco BGP switch must be configured to use a unique key for each autonomous system (AS) that it peers with.

    &lt;VulnDiscussion&gt;If the same keys are used between eBGP neighbors, the chance of a hacker compromising any of the BGP sessions increases. It i...
    Rule Medium Severity
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules