Skip to content

Standard System Security Profile for openEuler 22.03 LTS

Rules and Groups employed by this XCCDF Profile

  • Enable Kernel Parameter to Ignore Bogus ICMP Error Responses on IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.icmp_ignore_bogus_error_responses</code> kernel parameter, run the following command: <pre>$ sudo s...
    Rule Unknown Severity
  • Enable Kernel Parameter to Use TCP Syncookies on Network Interfaces

    To set the runtime status of the <code>net.ipv4.tcp_syncookies</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.t...
    Rule Medium Severity
  • Network Parameters for Hosts Only

    If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...
    Group
  • Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...
    Rule Medium Severity
  • Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces by Default

    To set the runtime status of the <code>net.ipv4.conf.default.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...
    Rule Medium Severity
  • Disable Kernel Parameter for IP Forwarding on IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.ip_forward</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.ip_fo...
    Rule Medium Severity
  • nftables

    <code>If firewalld or iptables are being used in your environment, please follow the guidance in their respective section and pass-over the guidanc...
    Group
  • Verify nftables Service is Enabled

    The nftables service allows for the loading of nftables rulesets during boot, or starting on the nftables service The <code>nftables</code> servic...
    Rule Medium Severity
  • Ensure nftables Default Deny Firewall Policy

    Base chain policy is the default verdict that will be applied to packets reaching the end of the chain. There are two policies: accept (Default) an...
    Rule Medium Severity
  • Set nftables Configuration for Loopback Traffic

    Configure the loopback interface to accept traffic. Configure all other interfaces to deny traffic to the loopback network.
    Rule Medium Severity

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules