Skip to content
ATO Pathways
  Log In

I - Mission Critical Public

Rules and Groups employed by this XCCDF Profile

  • SRG-NET-000019-RTR-000003

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast switch must be configured to disable Protocol Independent Multicast (PIM) on all interfaces that are not required to support multicast routing.

    &lt;VulnDiscussion&gt;If multicast traffic is forwarded beyond the intended boundary, it is possible that it can be intercepted by unauthorized or ...
    Rule Medium Severity
    Show

  • SRG-NET-000019-RTR-000004

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast switch must be configured to bind a Protocol Independent Multicast (PIM) neighbor filter to interfaces that have PIM enabled.

    &lt;VulnDiscussion&gt;PIM is a routing protocol used to build multicast distribution trees for forwarding multicast traffic across the network infr...
    Rule Medium Severity
    Show

  • SRG-NET-000019-RTR-000005

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast edge switch must be configured to establish boundaries for administratively scoped multicast traffic.

    &lt;VulnDiscussion&gt;If multicast traffic is forwarded beyond the intended boundary, it is possible that it can be intercepted by unauthorized or ...
    Rule Low Severity
    Show

  • SRG-NET-000362-RTR-000120

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Rendezvous Point (RP) switch must be configured to limit the multicast forwarding cache so that its resources are not saturated by managing an overwhelming number of Protocol Independent Multicast (PIM) and Multicast Source Discovery Protocol (MSDP) source-active entries.

    &lt;VulnDiscussion&gt;MSDP peering between networks enables sharing of multicast source information. Enclaves with an existing multicast topology u...
    Rule Low Severity
    Show

  • SRG-NET-000019-RTR-000013

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Rendezvous Point (RP) switch must be configured to filter Protocol Independent Multicast (PIM) Register messages received from the Designated switch (DR) for any undesirable multicast groups and sources.

    &lt;VulnDiscussion&gt;Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast p...
    Rule Low Severity
    Show

  • SRG-NET-000019-RTR-000014

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Rendezvous Point (RP) switch must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the Designated Cisco switch (DR) for any undesirable multicast groups.

    &lt;VulnDiscussion&gt;Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast p...
    Rule Low Severity
    Show

  • SRG-NET-000362-RTR-000121

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Rendezvous Point (RP) must be configured to rate limit the number of Protocol Independent Multicast (PIM) Register messages.

    &lt;VulnDiscussion&gt;When a new source starts transmitting in a PIM Sparse Mode network, the DR will encapsulate the multicast packets into regist...
    Rule Medium Severity
    Show

  • SRG-NET-000364-RTR-000114

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Designated switch (DR) must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join only multicast groups that have been approved by the organization.

    &lt;VulnDiscussion&gt;Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., so...
    Rule Low Severity
    Show

  • SRG-NET-000364-RTR-000115

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Designated switch (DR) must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join a multicast group only from sources that have been approved by the organization.

    &lt;VulnDiscussion&gt;Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., so...
    Rule Medium Severity
    Show

  • SRG-NET-000362-RTR-000122

    <GroupDescription></GroupDescription>
    Group
    Show

  • The Cisco multicast Designated switch (DR) must be configured to limit the number of mroute states resulting from Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Host Membership Reports.

    &lt;VulnDiscussion&gt;The current multicast paradigm can let any host join any multicast group at any time by sending an IGMP or MLD membership rep...
    Rule Medium Severity
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules