OSPP - Protection Profile for General Purpose Operating Systems v4.2.1
Rules and Groups employed by this XCCDF Profile
-
Network Configuration and Firewalls
Most systems must be connected to a network of some sort, and this brings with it the substantial risk of network attack. This section discusses th...Group -
firewalld
The dynamic firewall daemon <code>firewalld</code> provides a dynamically managed firewall with support for network “zones” to assign a level of tr...Group -
Inspect and Activate Default firewalld Rules
Firewalls can be used to separate networks into different zones based on the level of trust the user has decided to place on the devices and traffi...Group -
Verify firewalld Enabled
Thefirewalld
service can be enabled with the following command:$ sudo systemctl enable firewalld.service
Rule Medium Severity -
IPv6
The system includes support for Internet Protocol version 6. A major and often-mentioned improvement over IPv4 is its enormous increase in the numb...Group -
Configure IPv6 Settings if Necessary
A major feature of IPv6 is the extent to which systems implementing it can automatically configure their networking devices using information from ...Group -
Configure Accepting Router Advertisements on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ip...Rule Medium Severity -
Disable Accepting ICMP Redirects for All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Disable Accepting Router Advertisements on all IPv6 Interfaces by Default
To set the runtime status of the <code>net.ipv6.conf.default.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ne...Rule Medium Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.
Capacity
Modules