Skip to content

C2S for Red Hat Enterprise Linux 7

Rules and Groups employed by this XCCDF Profile

  • Enable Kernel Parameter to Use TCP Syncookies on Network Interfaces

    To set the runtime status of the <code>net.ipv4.tcp_syncookies</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.t...
    Rule Medium Severity
  • Network Parameters for Hosts Only

    If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...
    Group
  • Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...
    Rule Medium Severity
  • Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces by Default

    To set the runtime status of the <code>net.ipv4.conf.default.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...
    Rule Medium Severity
  • Disable Kernel Parameter for IP Forwarding on IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.ip_forward</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.ip_fo...
    Rule Medium Severity
  • Uncommon Network Protocols

    The system includes support for several network protocols which are not commonly used. Although security vulnerabilities in kernel networking code ...
    Group
  • Disable DCCP Support

    The Datagram Congestion Control Protocol (DCCP) is a relatively new transport layer protocol, designed to support streaming media and telephony. T...
    Rule Medium Severity
  • Disable SCTP Support

    The Stream Control Transmission Protocol (SCTP) is a transport layer protocol, designed to support the idea of message-oriented communication, with...
    Rule Medium Severity
  • File Permissions and Masks

    Traditional Unix security relies heavily on file and directory permissions to prevent unauthorized users from reading or modifying files to which t...
    Group
  • Verify Permissions on Important Files and Directories

    Permissions for many files on a system must be set restrictively to ensure sensitive information is properly protected. This section discusses impo...
    Group
  • Verify that All World-Writable Directories Have Sticky Bits Set

    When the so-called 'sticky bit' is set on a directory, only the owner of a given file may remove that file from the directory. Without the sticky b...
    Rule Medium Severity
  • Ensure All SGID Executables Are Authorized

    The SGID (set group id) bit should be set only on files that were installed via authorized means. A straightforward means of identifying unauthoriz...
    Rule Medium Severity
  • Ensure All SUID Executables Are Authorized

    The SUID (set user id) bit should be set only on files that were installed via authorized means. A straightforward means of identifying unauthorize...
    Rule Medium Severity
  • Ensure No World-Writable Files Exist

    It is generally a good idea to remove global (other) write access to a file when it is discovered. However, check with documentation for specific a...
    Rule Medium Severity
  • Ensure All Files Are Owned by a Group

    If any file is not group-owned by a group present in /etc/group, the cause of the lack of group-ownership must be investigated. Following this, tho...
    Rule Medium Severity
  • Ensure All Files Are Owned by a User

    If any files are not owned by a user, then the cause of their lack of ownership should be investigated. Following this, the files should be deleted...
    Rule Medium Severity
  • Verify Permissions on Files with Local Account Information and Credentials

    The default restrictive permissions for files which act as important security databases such as <code>passwd</code>, <code>shadow</code>, <code>gro...
    Group
  • Verify Group Who Owns group File

    To properly set the group owner of /etc/group, run the command:
    $ sudo chgrp root /etc/group
    Rule Medium Severity
  • Verify Group Who Owns gshadow File

    To properly set the group owner of /etc/gshadow, run the command:
    $ sudo chgrp root /etc/gshadow
    Rule Medium Severity
  • Verify Group Who Owns passwd File

    To properly set the group owner of /etc/passwd, run the command:
    $ sudo chgrp root /etc/passwd
    Rule Medium Severity

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules