DRAFT - ANSSI-BP-028 (intermediary)
Rules and Groups employed by this XCCDF Profile
-
Set the UEFI Boot Loader Password
The grub2 boot loader should have a superuser account and password protection enabled to protect boot-time settings. <br><br> Since plaintext passw...Rule High Severity -
Network Configuration and Firewalls
Most systems must be connected to a network of some sort, and this brings with it the substantial risk of network attack. This section discusses th...Group -
IPv6
The system includes support for Internet Protocol version 6. A major and often-mentioned improvement over IPv4 is its enormous increase in the numb...Group -
Configure IPv6 Settings if Necessary
A major feature of IPv6 is the extent to which systems implementing it can automatically configure their networking devices using information from ...Group -
Disable Accepting ICMP Redirects for All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Disable Kernel Parameter for Accepting ICMP Redirects by Default on IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.default.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysct...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on IPv6 Interfaces by Default
To set the runtime status of the <code>net.ipv6.conf.default.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sy...Rule Medium Severity -
Kernel Parameters Which Affect Networking
The <code>sysctl</code> utility is used to set parameters which affect the operation of the Linux kernel. Kernel parameters which affect networking...Group -
Network Related Kernel Runtime Parameters for Hosts and Routers
Certain kernel parameters should be set for systems which are acting as either hosts or routers to improve the system's ability defend against cert...Group -
Disable Accepting Packets Routed Between Local Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_local</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...Rule Medium Severity -
Disable Accepting ICMP Redirects for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Configure ARP filtering for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Configure Response Mode of ARP Requests for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_ignore</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Prevent Routing External Traffic to Local Loopback on All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.route_localnet</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...Rule Medium Severity -
Enable Kernel Parameter to Use Reverse Path Filtering on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.rp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ip...Rule Medium Severity -
Disable Kernel Parameter for Accepting Secure ICMP Redirects on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.secure_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...Rule Medium Severity -
Disable Kernel Parameter for Accepting ICMP Redirects by Default on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.default.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysct...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on IPv4 Interfaces by Default
To set the runtime status of the <code>net.ipv4.conf.default.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sy...Rule Medium Severity -
Enable Kernel Parameter to Use Reverse Path Filtering on all IPv4 Interfaces by Default
To set the runtime status of the <code>net.ipv4.conf.default.rp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ne...Rule Medium Severity -
Configure Kernel Parameter for Accepting Secure Redirects By Default
To set the runtime status of the <code>net.ipv4.conf.default.secure_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysct...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects by Default
To set the runtime status of the <code>net.ipv4.conf.default.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Enable Kernel Parameter to Ignore Bogus ICMP Error Responses on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.icmp_ignore_bogus_error_responses</code> kernel parameter, run the following command: <pre>$ sudo s...Rule Unknown Severity -
Enable Kernel Parameter to Use TCP Syncookies on Network Interfaces
To set the runtime status of the <code>net.ipv4.tcp_syncookies</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.t...Rule Medium Severity -
Network Parameters for Hosts Only
If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...Group -
Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...Rule Medium Severity -
Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces by Default
To set the runtime status of the <code>net.ipv4.conf.default.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...Rule Medium Severity -
Disable Kernel Parameter for IP Forwarding on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.ip_forward</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.ip_fo...Rule Medium Severity -
File Permissions and Masks
Traditional Unix security relies heavily on file and directory permissions to prevent unauthorized users from reading or modifying files to which t...Group -
Verify Permissions on Important Files and Directories
Permissions for many files on a system must be set restrictively to ensure sensitive information is properly protected. This section discusses impo...Group -
Verify that All World-Writable Directories Have Sticky Bits Set
When the so-called 'sticky bit' is set on a directory, only the owner of a given file may remove that file from the directory. Without the sticky b...Rule Medium Severity -
Ensure No World-Writable Files Exist
It is generally a good idea to remove global (other) write access to a file when it is discovered. However, check with documentation for specific a...Rule Medium Severity -
Enable Kernel Parameter to Enforce DAC on Hardlinks
To set the runtime status of the <code>fs.protected_hardlinks</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w fs.protecte...Rule Medium Severity -
Enable Kernel Parameter to Enforce DAC on Symlinks
To set the runtime status of the <code>fs.protected_symlinks</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w fs.protected...Rule Medium Severity -
Verify Permissions on Files with Local Account Information and Credentials
The default restrictive permissions for files which act as important security databases such as <code>passwd</code>, <code>shadow</code>, <code>gro...Group -
Verify User Who Owns gshadow File
To properly set the owner of/etc/gshadow, run the command:$ sudo chown root /etc/gshadow
Rule Medium Severity -
Verify User Who Owns shadow File
To properly set the owner of/etc/shadow, run the command:$ sudo chown root /etc/shadow
Rule Medium Severity -
Verify Permissions on group File
To properly set the permissions of/etc/group, run the command:$ sudo chmod 0644 /etc/group
Rule Medium Severity -
Verify Permissions on gshadow File
To properly set the permissions of/etc/gshadow, run the command:$ sudo chmod 0000 /etc/gshadow
Rule Medium Severity -
Verify Permissions on passwd File
To properly set the permissions of/etc/passwd, run the command:$ sudo chmod 0644 /etc/passwd
Rule Medium Severity -
Verify Permissions on shadow File
To properly set the permissions of/etc/shadow, run the command:$ sudo chmod 0000 /etc/shadow
Rule Medium Severity -
Restrict Partition Mount Options
System partitions can be mounted with certain options that limit what files on those partitions can do. These options are set in the <code>/etc/fst...Group -
Add nosuid Option to /boot
The <code>nosuid</code> mount option can be used to prevent execution of setuid programs in <code>/boot</code>. The SUID and SGID permissions shoul...Rule Medium Severity -
Add nosuid Option to /home
The <code>nosuid</code> mount option can be used to prevent execution of setuid programs in <code>/home</code>. The SUID and SGID permissions shoul...Rule Medium Severity -
Add nodev Option to Non-Root Local Partitions
The <code>nodev</code> mount option prevents files from being interpreted as character or block devices. Legitimate character and block devices sho...Rule Medium Severity -
Add noexec Option to /tmp
The <code>noexec</code> mount option can be used to prevent binaries from being executed out of <code>/tmp</code>. Add the <code>noexec</code> opti...Rule Medium Severity -
Add nosuid Option to /tmp
The <code>nosuid</code> mount option can be used to prevent execution of setuid programs in <code>/tmp</code>. The SUID and SGID permissions should...Rule Medium Severity -
Add noexec Option to /var/log
The <code>noexec</code> mount option can be used to prevent binaries from being executed out of <code>/var/log</code>. Add the <code>noexec</code> ...Rule Medium Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.