Skip to content
ATO Pathways
  Log In

Guide to the Secure Configuration of Debian 10

Rules, Groups, and Values defined within the XCCDF Benchmark

  • System Settings

    Contains rules that check correct system settings.
    Group
    Show

  • Installing and Maintaining Software

    The following sections contain information on security-relevant choices during the initial operating system installation process and the setup of s...
    Group
    Show

  • Prefer to use a 64-bit Operating System when supported

    Prefer installation of 64-bit operating systems when the CPU supports it.
    Rule Medium Severity
    Show

  • System and Software Integrity

    System and software integrity can be gained by installing antivirus, increasing system encryption strength with FIPS, verifying installed software,...
    Group
    Show

  • Software Integrity Checking

    Both the AIDE (Advanced Intrusion Detection Environment) software and the RPM package management system provide mechanisms for verifying the integr...
    Group
    Show

  • Integrity Scan Notification Email Address

    Specify the email address for designated personnel if baseline configurations are changed in an unauthorized manner.
    Value
    Show

  • Verify Integrity with RPM

    The RPM package management system includes the ability to verify the integrity of installed packages by comparing the installed files with informat...
    Group
    Show

  • Verify Integrity with AIDE

    AIDE conducts integrity checks by comparing information about files with previously-gathered information. Ideally, the AIDE database is created imm...
    Group
    Show

  • Install AIDE

    The aide package can be installed with the following command: 
    $ apt-get install aide
    Rule Medium Severity
    Show

  • net.ipv6.conf.default.accept_ra_pinfo

    Accept prefix information in router advertisements?
    Value
    Show

  • net.ipv6.conf.default.accept_ra_rtr_pref

    Accept router preference in router advertisements?
    Value
    Show

  • net.ipv6.conf.default.accept_ra

    Accept default router advertisements by default?
    Value
    Show

  • net.ipv6.conf.default.accept_redirects

    Toggle ICMP Redirect Acceptance By Default
    Value
    Show

  • net.ipv4.tcp_invalid_ratelimit

    Configure the maximal rate for sending duplicate acknowledgments in response to incoming invalid TCP packets.
    Value
    Show

  • net.ipv4.tcp_rfc1337

    Enable to enable TCP behavior conformant with RFC 1337
    Value
    Show

  • net.ipv4.tcp_syncookies

    Enable to turn on TCP SYN Cookie Protection
    Value
    Show

  • Daemon Umask

    The umask is a per-process setting which limits the default permissions for creation of new files and directories. The system includes initializati...
    Group
    Show

  • daemon umask

    Enter umask for daemons
    Value
    Show

  • ftpd_anon_write SELinux Boolean

    default - Default SELinux boolean setting.
    on - SELinux boolean is enabled.
    off - SELinux boolean is disabled.
    Value
    Show

  • guest_exec_content SELinux Boolean

    default - Default SELinux boolean setting.
    on - SELinux boolean is enabled.
    off - SELinux boolean is disabled.
    Value
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules