Guide to the Secure Configuration of OpenEmbedded
Rules, Groups, and Values defined within the XCCDF Benchmark
-
net.ipv4.conf.default.accept_source_route
Disable IP source routing?Value -
net.ipv4.conf.default.log_martians
Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect PacketsValue -
Configure ARP filtering for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Configure Response Mode of ARP Requests for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_ignore</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Prevent Routing External Traffic to Local Loopback on All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.route_localnet</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects by Default
To set the runtime status of the <code>net.ipv4.conf.default.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Network Parameters for Hosts Only
If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...Group -
nftables
<code>If firewalld or iptables are being used in your environment, please follow the guidance in their respective section and pass-over the guidanc...Group -
Nftables Base Chain Hooks
The possible hooks which can be used to configure the base chain are: <code>ingress</code> (only in netdev family since Linux kernel 4.2, and inet ...Value -
Nftables Chain Names
The rules in nftables are attached to chains. Unlike in iptables, there are no predefined chains like INPUT, OUTPUT, etc. Instead, to filter pack...Value -
Nftables Base Chain Priorities
Each nftables base chain is assigned a priority that defines its ordering among other base chains, flowtables, and Netfilter internal operations a...Value -
Nftables Base Chain Types
Base chains are those that are registered into the Netfilter hooks, i.e. these chains see packets flowing through the Linux TCP/IP stack. The poss...Value -
Nftables Families
Netfilter enables filtering at multiple networking levels. With iptables there is a separate tool for each level: iptables, ip6tables, arptables, ...Value -
Nftables Master configuration file
The file which contains top level configuration for nftables service, and with which, the service is started.Value -
Nftables Tables
Tables in nftables hold chains. Each table only has one address family and only applies to packets of this family. Tables can have one of six fami...Value -
SuSEfirewall2
The SuSEfirewall2 provides a managed firewall.Group -
Uncomplicated Firewall (ufw)
The Linux kernel in Ubuntu provides a packet filtering system called netfilter, and the traditional interface for manipulating netfilter are the ip...Group -
Verify ufw Enabled
Theufwservice can be enabled with the following command:$ sudo systemctl enable ufw.service
Rule Medium Severity -
Uncommon Network Protocols
The system includes support for several network protocols which are not commonly used. Although security vulnerabilities in kernel networking code ...Group
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.