Guide to the Secure Configuration of OpenEmbedded
Rules, Groups, and Values defined within the XCCDF Benchmark
-
net.ipv4.conf.default.accept_source_route
Disable IP source routing?Value -
net.ipv4.conf.default.log_martians
Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect PacketsValue -
Configure ARP filtering for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Configure Response Mode of ARP Requests for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_ignore</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Prevent Routing External Traffic to Local Loopback on All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.route_localnet</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...Rule Medium Severity -
Configure Sending and Accepting Shared Media Redirects by Default
To set the runtime status of the <code>net.ipv4.conf.default.shared_media</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Network Parameters for Hosts Only
If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...Group -
nftables
<code>If firewalld or iptables are being used in your environment, please follow the guidance in their respective section and pass-over the guidanc...Group -
Nftables Base Chain Hooks
The possible hooks which can be used to configure the base chain are: <code>ingress</code> (only in netdev family since Linux kernel 4.2, and inet ...Value -
Nftables Chain Names
The rules in nftables are attached to chains. Unlike in iptables, there are no predefined chains like INPUT, OUTPUT, etc. Instead, to filter pack...Value -
Nftables Base Chain Priorities
Each nftables base chain is assigned a priority that defines its ordering among other base chains, flowtables, and Netfilter internal operations a...Value -
Nftables Base Chain Types
Base chains are those that are registered into the Netfilter hooks, i.e. these chains see packets flowing through the Linux TCP/IP stack. The poss...Value -
Nftables Families
Netfilter enables filtering at multiple networking levels. With iptables there is a separate tool for each level: iptables, ip6tables, arptables, ...Value -
Nftables Master configuration file
The file which contains top level configuration for nftables service, and with which, the service is started.Value -
Nftables Tables
Tables in nftables hold chains. Each table only has one address family and only applies to packets of this family. Tables can have one of six fami...Value -
SuSEfirewall2
The SuSEfirewall2 provides a managed firewall.Group -
Uncomplicated Firewall (ufw)
The Linux kernel in Ubuntu provides a packet filtering system called netfilter, and the traditional interface for manipulating netfilter are the ip...Group -
Verify ufw Enabled
Theufwservice can be enabled with the following command:$ sudo systemctl enable ufw.service
Rule Medium Severity -
Uncommon Network Protocols
The system includes support for several network protocols which are not commonly used. Although security vulnerabilities in kernel networking code ...Group -
Disable RDS Support
The Reliable Datagram Sockets (RDS) protocol is a transport layer protocol designed to provide reliable high-bandwidth, low-latency communications ...Rule Low Severity -
Disable TIPC Support
The Transparent Inter-Process Communication (TIPC) protocol is designed to provide communications between nodes in a cluster. To configure the sys...Rule Low Severity -
Deactivate Wireless Network Interfaces
Deactivating wireless network interfaces should prevent normal usage of the wireless capability. <br><br> Configure the system to disable all wire...Rule Medium Severity -
Disable Unused Interfaces
Network interfaces expand the attack surface of the system. Unused interfaces are not monitored or controlled, and should be disabled. <br><br> If...Group -
Transport Layer Security Support
Support for Transport Layer Security (TLS), and its predecessor, the Secure Sockets Layer (SSL), is included in Red Hat Enterprise Linux in the Ope...Group -
Network Manager
The NetworkManager daemon configures a variety of network connections. This section discusses how to configure NetworkManager.Group -
NetoworkManager DNS Mode
This sets how NetworkManager handles DNS. none - NetworkManager will not modify resolv.conf. default - NetworkManager will update /etc/resolv.con...Value -
File Permissions and Masks
Traditional Unix security relies heavily on file and directory permissions to prevent unauthorized users from reading or modifying files to which t...Group -
Verify Permissions on Important Files and Directories
Permissions for many files on a system must be set restrictively to ensure sensitive information is properly protected. This section discusses impo...Group -
Verify that All World-Writable Directories Have Sticky Bits Set
When the so-called 'sticky bit' is set on a directory, only the owner of a given file may remove that file from the directory. Without the sticky b...Rule Medium Severity -
Verify that local System.map file (if exists) is readable only by root
Files containing sensitive informations should be protected by restrictive permissions. Most of the time, there is no need that these files need ...Rule Unknown Severity -
Enable SSL Support
SSL should be used to encrypt network traffic between the Dovecot server and its clients. Users must authenticate to the Dovecot server in order ...Group -
Ensure All Files Are Owned by a Group
If any file is not group-owned by a group present in /etc/group, the cause of the lack of group-ownership must be investigated. Following this, tho...Rule Medium Severity -
Enable Kernel Parameter to Enforce DAC on Hardlinks
To set the runtime status of the <code>fs.protected_hardlinks</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w fs.protecte...Rule Medium Severity -
Enable Kernel Parameter to Enforce DAC on Symlinks
To set the runtime status of the <code>fs.protected_symlinks</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w fs.protected...Rule Medium Severity -
Verify Permissions on Files with Local Account Information and Credentials
The default restrictive permissions for files which act as important security databases such as <code>passwd</code>, <code>shadow</code>, <code>gro...Group -
Verify Group Who Owns Backup group File
To properly set the group owner of/etc/group-, run the command:$ sudo chgrp root /etc/group-
Rule Medium Severity -
Verify Group Who Owns Backup gshadow File
To properly set the group owner of/etc/gshadow-, run the command:$ sudo chgrp root /etc/gshadow-
Rule Medium Severity -
Verify Group Who Owns Backup passwd File
To properly set the group owner of/etc/passwd-, run the command:$ sudo chgrp root /etc/passwd-
Rule Medium Severity -
Verify User Who Owns Backup shadow File
To properly set the group owner of/etc/shadow-, run the command:$ sudo chgrp root /etc/shadow-
Rule Medium Severity -
Verify Group Who Owns group File
To properly set the group owner of/etc/group, run the command:$ sudo chgrp root /etc/group
Rule Medium Severity -
Verify Group Who Owns gshadow File
To properly set the group owner of/etc/gshadow, run the command:$ sudo chgrp root /etc/gshadow
Rule Medium Severity -
Verify Group Who Owns passwd File
To properly set the group owner of/etc/passwd, run the command:$ sudo chgrp root /etc/passwd
Rule Medium Severity -
Verify Group Who Owns shadow File
To properly set the group owner of/etc/shadow, run the command:$ sudo chgrp root /etc/shadow
Rule Medium Severity -
Verify that Shared Library Directories Have Root Ownership
System-wide shared library files, which are linked to executables during process load time or run time, are stored in the following directories by ...Rule Medium Severity -
Verify that System Executable Directories Have Restrictive Permissions
System executables are stored in the following directories by default: <pre>/bin /sbin /usr/bin /usr/sbin /usr/local/bin /usr/local/sbin</pre> Thes...Rule Medium Severity -
Verify that Shared Library Directories Have Restrictive Permissions
System-wide shared library directories, which contain are linked to executables during process load time or run time, are stored in the following d...Rule Medium Severity -
Verify that System Executables Have Root Ownership
System executables are stored in the following directories by default: <pre>/bin /sbin /usr/bin /usr/libexec /usr/local/bin /usr/local/sbin /usr/sb...Rule Medium Severity -
Verify that Shared Library Files Have Root Ownership
System-wide shared library files, which are linked to executables during process load time or run time, are stored in the following directories by ...Rule Medium Severity -
Verify that System Executables Have Restrictive Permissions
System executables are stored in the following directories by default: <pre>/bin /sbin /usr/bin /usr/libexec /usr/local/bin /usr/local/sbin /usr/sb...Rule Medium Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.