Guide to the Secure Configuration of Anolis OS 8
Rules, Groups, and Values defined within the XCCDF Benchmark
-
Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces by Default
To set the runtime status of the <code>net.ipv4.conf.default.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...Rule Medium Severity -
Disable Kernel Parameter for IP Forwarding on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.ip_forward</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.ip_fo...Rule Medium Severity -
conman_can_network SELinux Boolean
default - Default SELinux boolean setting.
on - SELinux boolean is enabled.
off - SELinux boolean is disabled.Value -
container_connect_any SELinux Boolean
default - Default SELinux boolean setting.
on - SELinux boolean is enabled.
off - SELinux boolean is disabled.Value -
nftables
<code>If firewalld or iptables are being used in your environment, please follow the guidance in their respective section and pass-over the guidanc...Group -
Nftables Base Chain Hooks
The possible hooks which can be used to configure the base chain are: <code>ingress</code> (only in netdev family since Linux kernel 4.2, and inet ...Value -
Nftables Chain Names
The rules in nftables are attached to chains. Unlike in iptables, there are no predefined chains like INPUT, OUTPUT, etc. Instead, to filter pack...Value -
Nftables Base Chain Policies
This is the default verdict that will be applied to packets reaching the end of the chain (i.e, no more rules to be evaluated against). Currently ...Value -
Nftables Base Chain Priorities
Each nftables base chain is assigned a priority that defines its ordering among other base chains, flowtables, and Netfilter internal operations a...Value -
Nftables Base Chain Types
Base chains are those that are registered into the Netfilter hooks, i.e. these chains see packets flowing through the Linux TCP/IP stack. The poss...Value -
Nftables Families
Netfilter enables filtering at multiple networking levels. With iptables there is a separate tool for each level: iptables, ip6tables, arptables, ...Value -
Nftables Master configuration file
The file which contains top level configuration for nftables service, and with which, the service is started.Value -
Nftables Tables
Tables in nftables hold chains. Each table only has one address family and only applies to packets of this family. Tables can have one of six fami...Value -
SuSEfirewall2
The SuSEfirewall2 provides a managed firewall.Group -
cron_can_relabel SELinux Boolean
default - Default SELinux boolean setting.
on - SELinux boolean is enabled.
off - SELinux boolean is disabled.Value -
Uncomplicated Firewall (ufw)
The Linux kernel in Ubuntu provides a packet filtering system called netfilter, and the traditional interface for manipulating netfilter are the ip...Group -
Verify ufw Enabled
Theufwservice can be enabled with the following command:$ sudo systemctl enable ufw.service
Rule Medium Severity -
Uncommon Network Protocols
The system includes support for several network protocols which are not commonly used. Although security vulnerabilities in kernel networking code ...Group -
Disable DCCP Support
The Datagram Congestion Control Protocol (DCCP) is a relatively new transport layer protocol, designed to support streaming media and telephony. T...Rule Medium Severity -
Disable RDS Support
The Reliable Datagram Sockets (RDS) protocol is a transport layer protocol designed to provide reliable high-bandwidth, low-latency communications ...Rule Low Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.