Skip to content

Guide to the Secure Configuration of Red Hat Virtualization 4

Rules, Groups, and Values defined within the XCCDF Benchmark

  • net.ipv4.conf.default.arp_filter

    Controls whether the ARP filter is enabled or not. 1 - Allows you to have multiple network interfaces on the same subnet, and have the ARPs for ea...
    Value
  • net.ipv4.conf.default.arp_ignore

    Control the response modes for ARP queries that resolve local target IP addresses: 0 - (default): reply for any local target IP address, configure...
    Value
  • net.ipv4.conf.all.forwarding

    Toggle IPv4 Forwarding
    Value
  • net.ipv4.conf.all.log_martians

    Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect Packets
    Value
  • net.ipv4.conf.all.rp_filter

    Enable to enforce sanity checking, also called ingress filtering or egress filtering. The point is to drop a packet if the source and destination I...
    Value
  • net.ipv4.conf.all.secure_redirects

    Enable to prevent hijacking of routing path by only allowing redirects from gateways known in routing table. Disable to refuse acceptance of secure...
    Value
  • net.ipv4.conf.all.shared_media

    Controls whether the system can send (router) or accept (host) RFC1620 shared media redirects. <code>shared_media</code> for the interface will be ...
    Value
  • net.ipv4.conf.default.accept_redirects

    Disable ICMP Redirect Acceptance?
    Value
  • net.ipv4.conf.default.accept_source_route

    Disable IP source routing?
    Value
  • net.ipv4.conf.default.log_martians

    Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect Packets
    Value
  • Disable Accepting Packets Routed Between Local Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.accept_local</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...
    Rule Medium Severity
  • Disable Accepting ICMP Redirects for All IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...
    Rule Medium Severity
  • Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...
    Rule Medium Severity
  • Configure ARP filtering for All IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.arp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...
    Rule Medium Severity
  • Configure Response Mode of ARP Requests for All IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.arp_ignore</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...
    Rule Medium Severity
  • Enable Kernel Parameter to Log Martian Packets on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.log_martians</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...
    Rule Unknown Severity
  • Prevent Routing External Traffic to Local Loopback on All IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.route_localnet</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...
    Rule Medium Severity
  • Enable Kernel Parameter to Use Reverse Path Filtering on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.rp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ip...
    Rule Medium Severity
  • cron_can_relabel SELinux Boolean

    default - Default SELinux boolean setting.
    on - SELinux boolean is enabled.
    off - SELinux boolean is disabled.
    Value
  • Disable Kernel Parameter for Accepting Secure ICMP Redirects on all IPv4 Interfaces

    To set the runtime status of the <code>net.ipv4.conf.all.secure_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...
    Rule Medium Severity

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules