Skip to content
ATO Pathways
  Log In

Guide to the Secure Configuration of Red Hat Virtualization 4

Rules, Groups, and Values defined within the XCCDF Benchmark

  • Disable IPv6 Addressing on All IPv6 Interfaces

    To disable support for (<code>ipv6</code>) addressing on all interface add the following line to <code>/etc/sysctl.d/ipv6.conf</code> (or another f...
    Rule Medium Severity
    Show

  • Disable IPv6 Addressing on IPv6 Interfaces by Default

    To disable support for (<code>ipv6</code>) addressing on interfaces by default add the following line to <code>/etc/sysctl.d/ipv6.conf</code> (or a...
    Rule Medium Severity
    Show

  • net.ipv4.icmp_ignore_bogus_error_responses

    Enable to prevent unnecessary logging
    Value
    Show

  • Use Privacy Extensions for Address

    To introduce randomness into the automatic generation of IPv6 addresses, add or correct the following line in <code>/etc/sysconfig/network-scripts/...
    Rule Unknown Severity
    Show

  • Configure Accepting Router Advertisements on All IPv6 Interfaces

    To set the runtime status of the <code>net.ipv6.conf.all.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ip...
    Rule Medium Severity
    Show

  • Disable Accepting ICMP Redirects for All IPv6 Interfaces

    To set the runtime status of the <code>net.ipv6.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...
    Rule Medium Severity
    Show

  • Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv6 Interfaces

    To set the runtime status of the <code>net.ipv6.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...
    Rule Medium Severity
    Show

  • Disable Kernel Parameter for IPv6 Forwarding

    To set the runtime status of the <code>net.ipv6.conf.all.forwarding</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...
    Rule Medium Severity
    Show

  • Disable Accepting Router Advertisements on all IPv6 Interfaces by Default

    To set the runtime status of the <code>net.ipv6.conf.default.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ne...
    Rule Medium Severity
    Show

  • Disable Kernel Parameter for Accepting ICMP Redirects by Default on IPv6 Interfaces

    To set the runtime status of the <code>net.ipv6.conf.default.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysct...
    Rule Medium Severity
    Show

  • Disable Kernel Parameter for Accepting Source-Routed Packets on IPv6 Interfaces by Default

    To set the runtime status of the <code>net.ipv6.conf.default.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sy...
    Rule Medium Severity
    Show

  • net.ipv4.tcp_invalid_ratelimit

    Configure the maximal rate for sending duplicate acknowledgments in response to incoming invalid TCP packets.
    Value
    Show

  • net.ipv4.tcp_rfc1337

    Enable to enable TCP behavior conformant with RFC 1337
    Value
    Show

  • net.ipv4.tcp_syncookies

    Enable to turn on TCP SYN Cookie Protection
    Value
    Show

  • container_connect_any SELinux Boolean

    default - Default SELinux boolean setting.
    on - SELinux boolean is enabled.
    off - SELinux boolean is disabled.
    Value
    Show

  • Limit Network-Transmitted Configuration if Using Static IPv6 Addresses

    To limit the configuration information requested from other systems and accepted from the network on a system that uses statically-configured IPv6 ...
    Group
    Show

  • Kernel Parameters Which Affect Networking

    The <code>sysctl</code> utility is used to set parameters which affect the operation of the Linux kernel. Kernel parameters which affect networking...
    Group
    Show

  • Network Related Kernel Runtime Parameters for Hosts and Routers

    Certain kernel parameters should be set for systems which are acting as either hosts or routers to improve the system's ability defend against cert...
    Group
    Show

  • net.ipv4.conf.all.accept_redirects

    Disable ICMP Redirect Acceptance
    Value
    Show

  • net.ipv4.conf.all.accept_source_route

    Trackers could be using source-routed packets to generate traffic that seems to be intra-net, but actually was created outside and has been redirec...
    Value
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules