Guide to the Secure Configuration of Red Hat Enterprise Linux 9
Rules, Groups, and Values defined within the XCCDF Benchmark
-
Network Related Kernel Runtime Parameters for Hosts and Routers
Certain kernel parameters should be set for systems which are acting as either hosts or routers to improve the system's ability defend against cert...Group -
net.ipv4.conf.all.accept_redirects
Disable ICMP Redirect AcceptanceValue -
net.ipv4.conf.all.accept_source_route
Trackers could be using source-routed packets to generate traffic that seems to be intra-net, but actually was created outside and has been redirec...Value -
net.ipv4.conf.default.arp_filter
Controls whether the ARP filter is enabled or not. 1 - Allows you to have multiple network interfaces on the same subnet, and have the ARPs for ea...Value -
net.ipv4.conf.default.arp_ignore
Control the response modes for ARP queries that resolve local target IP addresses: 0 - (default): reply for any local target IP address, configure...Value -
net.ipv4.conf.all.forwarding
Toggle IPv4 ForwardingValue -
net.ipv4.conf.all.log_martians
Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect PacketsValue -
net.ipv4.conf.all.rp_filter
Enable to enforce sanity checking, also called ingress filtering or egress filtering. The point is to drop a packet if the source and destination I...Value -
net.ipv4.conf.all.secure_redirects
Enable to prevent hijacking of routing path by only allowing redirects from gateways known in routing table. Disable to refuse acceptance of secure...Value -
net.ipv4.conf.all.shared_media
Controls whether the system can send (router) or accept (host) RFC1620 shared media redirects. <code>shared_media</code> for the interface will be ...Value -
net.ipv4.conf.default.accept_redirects
Disable ICMP Redirect Acceptance?Value -
net.ipv4.conf.default.accept_source_route
Disable IP source routing?Value -
net.ipv4.conf.default.log_martians
Disable so you don't Log Spoofed Packets, Source Routed Packets, Redirect PacketsValue -
Disable Accepting Packets Routed Between Local Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_local</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net...Rule Medium Severity -
Disable Accepting ICMP Redirects for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Configure ARP filtering for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_filter</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Configure Response Mode of ARP Requests for All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.arp_ignore</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Drop Gratuitious ARP frames on All IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.drop_gratuitous_arp</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Disable Kernel Parameter for IPv4 Forwarding on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.forwarding</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.