Guide to the Secure Configuration of Red Hat Enterprise Linux 8
Rules, Groups, and Values defined within the XCCDF Benchmark
-
Verify User Who Owns gshadow File
To properly set the owner of/etc/gshadow, run the command:$ sudo chown root /etc/gshadow
Rule Medium Severity -
Configure Kernel to Rate Limit Sending of Duplicate TCP Acknowledgments
Make sure that the system is configured to limit the maximal rate for sending duplicate acknowledgments in response to incoming TCP packets that ar...Rule Medium Severity -
Enable Kernel Parameter to Use TCP RFC 1337 on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.tcp_rfc1337</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.tcp_...Rule Medium Severity -
Enable Kernel Parameter to Use TCP Syncookies on Network Interfaces
To set the runtime status of the <code>net.ipv4.tcp_syncookies</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.t...Rule Medium Severity -
Network Parameters for Hosts Only
If the system is not going to be used as a router, then setting certain kernel parameters ensure that the host will not perform routing of network ...Group -
Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.conf.all.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w n...Rule Medium Severity -
Disable Kernel Parameter for Sending ICMP Redirects on all IPv4 Interfaces by Default
To set the runtime status of the <code>net.ipv4.conf.default.send_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...Rule Medium Severity -
Disable Kernel Parameter for IP Forwarding on IPv4 Interfaces
To set the runtime status of the <code>net.ipv4.ip_forward</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv4.ip_fo...Rule Medium Severity -
nftables
<code>If firewalld or iptables are being used in your environment, please follow the guidance in their respective section and pass-over the guidanc...Group -
daemons_use_tty SELinux Boolean
default - Default SELinux boolean setting.
on - SELinux boolean is enabled.
off - SELinux boolean is disabled.Value -
Disable TIPC Support
The Transparent Inter-Process Communication (TIPC) protocol is designed to provide communications between nodes in a cluster. To configure the sys...Rule Low Severity -
Nftables Base Chain Hooks
The possible hooks which can be used to configure the base chain are: <code>ingress</code> (only in netdev family since Linux kernel 4.2, and inet ...Value -
Nftables Chain Names
The rules in nftables are attached to chains. Unlike in iptables, there are no predefined chains like INPUT, OUTPUT, etc. Instead, to filter pack...Value -
Nftables Base Chain Policies
This is the default verdict that will be applied to packets reaching the end of the chain (i.e, no more rules to be evaluated against). Currently ...Value -
Nftables Base Chain Priorities
Each nftables base chain is assigned a priority that defines its ordering among other base chains, flowtables, and Netfilter internal operations a...Value -
Nftables Base Chain Types
Base chains are those that are registered into the Netfilter hooks, i.e. these chains see packets flowing through the Linux TCP/IP stack. The poss...Value -
Nftables Families
Netfilter enables filtering at multiple networking levels. With iptables there is a separate tool for each level: iptables, ip6tables, arptables, ...Value -
Nftables Master configuration file
The file which contains top level configuration for nftables service, and with which, the service is started.Value -
Nftables Tables
Tables in nftables hold chains. Each table only has one address family and only applies to packets of this family. Tables can have one of six fami...Value -
Install nftables Package
nftables provides a new in-kernel packet classification framework that is based on a network-specific Virtual Machine (VM) and a new nft userspace ...Rule Medium Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.