Skip to content
ATO Pathways
  Log In

Guide to the Secure Configuration of Red Hat Enterprise Linux 7

Rules, Groups, and Values defined within the XCCDF Benchmark

  • System Settings

    Contains rules that check correct system settings.
    Group
    Show

  • Installing and Maintaining Software

    The following sections contain information on security-relevant choices during the initial operating system installation process and the setup of s...
    Group
    Show

  • Prefer to use a 64-bit Operating System when supported

    Prefer installation of 64-bit operating systems when the CPU supports it.
    Rule Medium Severity
    Show

  • System and Software Integrity

    System and software integrity can be gained by installing antivirus, increasing system encryption strength with FIPS, verifying installed software,...
    Group
    Show

  • Package "prelink" Must not be Installed

    The prelink package can be removed with the following command: 
     $ sudo yum erase prelink
    Rule Medium Severity
    Show

  • Disable Prelinking

    The prelinking feature changes binaries in an attempt to decrease their startup time. In order to disable it, change or add the following line insi...
    Rule Medium Severity
    Show

  • net.ipv4.conf.default.rp_filter

    Enables source route verification
    Value
    Show

  • net.ipv6.conf.all.accept_ra_pinfo

    Accept prefix information in router advertisements?
    Value
    Show

  • net.ipv6.conf.all.accept_ra_rtr_pref

    Accept router preference in router advertisements?
    Value
    Show

  • net.ipv6.conf.all.accept_ra

    Accept all router advertisements?
    Value
    Show

  • net.ipv6.conf.all.accept_redirects

    Toggle ICMP Redirect Acceptance
    Value
    Show

  • Install AIDE

    The aide package can be installed with the following command: 
    $ sudo yum install aide
    Rule Medium Severity
    Show

  • Software Integrity Checking

    Both the AIDE (Advanced Intrusion Detection Environment) software and the RPM package management system provide mechanisms for verifying the integr...
    Group
    Show

  • Integrity Scan Notification Email Address

    Specify the email address for designated personnel if baseline configurations are changed in an unauthorized manner.
    Value
    Show

  • Verify Integrity with RPM

    The RPM package management system includes the ability to verify the integrity of installed packages by comparing the installed files with informat...
    Group
    Show

  • Verify and Correct Ownership with RPM

    The RPM package management system can check file ownership permissions of installed software packages, including many that are important to system ...
    Rule High Severity
    Show

  • Verify and Correct File Permissions with RPM

    The RPM package management system can check file access permissions of installed software packages, including many that are important to system sec...
    Rule High Severity
    Show

  • Verify Integrity with AIDE

    AIDE conducts integrity checks by comparing information about files with previously-gathered information. Ideally, the AIDE database is created imm...
    Group
    Show

  • Install Intrusion Detection Software

    The base Red Hat Enterprise Linux 7 platform already includes a sophisticated auditing system that can detect intruder activity, as well as SELinux...
    Rule High Severity
    Show

  • McAfee Endpoint Security Software

    In DoD environments, McAfee Host-based Security System (HBSS) and VirusScan Enterprise for Linux (VSEL) is required to be installed on all systems.
    Group
    Show

  • Build and Test AIDE Database

    Run the following command to generate a new database: <pre>$ sudo /usr/sbin/aide --init</pre> By default, the database will be written to the fil...
    Rule Medium Severity
    Show

  • Configure Periodic Execution of AIDE

    At a minimum, AIDE should be configured to run a weekly scan. To implement a daily execution of AIDE at 4:05am using cron, add the following line t...
    Rule Medium Severity
    Show

  • Configure Notification of Post-AIDE Scan Details

    AIDE should notify appropriate personnel of the details of a scan after the scan has been run. If AIDE has already been configured for periodic exe...
    Rule Medium Severity
    Show

  • Configure AIDE to Use FIPS 140-2 for Validating Hashes

    By default, the <code>sha512</code> option is added to the <code>NORMAL</code> ruleset in AIDE. If using a custom ruleset or the <code>sha512</code...
    Rule Medium Severity
    Show

  • Configure AIDE to Verify Access Control Lists (ACLs)

    By default, the <code>acl</code> option is added to the <code>FIPSR</code> ruleset in AIDE. If using a custom ruleset or the <code>acl</code> optio...
    Rule Low Severity
    Show

  • Configure AIDE to Verify Extended Attributes

    By default, the <code>xattrs</code> option is added to the <code>FIPSR</code> ruleset in AIDE. If using a custom ruleset or the <code>xattrs</code>...
    Rule Low Severity
    Show

  • The age of McAfee defintion file before requiring updating

    Specify the amount of time (in seconds) before McAfee definition files need to be updated.
    Value
    Show

  • Enable nails Service

    The <code>nails</code> service is used to run McAfee VirusScan Enterprise for Linux and McAfee Host-based Security System (HBSS) services. The <co...
    Rule Medium Severity
    Show

  • Federal Information Processing Standard (FIPS)

    The Federal Information Processing Standard (FIPS) is a computer security standard which is developed by the U.S. Government and industry working g...
    Group
    Show

  • Install the dracut-fips-aesni Package

    To enable FIPS on system that support the Advanced Encryption Standard (AES) or New Instructions (AES-NI) engine, the system requires that the <cod...
    Rule Medium Severity
    Show

  • Install the dracut-fips Package

    To enable FIPS, the system requires that the <code>dracut-fips</code> package be installed. The <code>dracut-fips</code> package can be installed w...
    Rule Medium Severity
    Show

  • Ensure '/etc/system-fips' exists

    On a system where FIPS mode is enabled, <code>/etc/system-fips</code> must exist. To enable FIPS mode, run the following command: <pre>fips-mode-se...
    Rule High Severity
    Show

  • Enable FIPS Mode in GRUB2

    To ensure FIPS mode is enabled, install package <code>dracut-fips</code>, and rebuild <code>initramfs</code> by running the following commands: <pr...
    Rule High Severity
    Show

  • System Cryptographic Policies

    Linux has the capability to centrally configure cryptographic polices. The command <code>update-crypto-policies</code> is used to set the policy ap...
    Group
    Show

  • SSH client RekeyLimit - size

    Specify the size component of the rekey limit. This limit signifies amount of data. After this amount of data is transferred through the connection...
    Value
    Show

  • SSH client RekeyLimit - time

    Specify the time component of the rekey limit. The session key is renegotiated after the defined amount of time passes. The number is followed by u...
    Value
    Show

  • The system-provided crypto policies

    Specify the crypto policy for the system.
    Value
    Show

  • Install McAfee Virus Scanning Software

    Install McAfee VirusScan Enterprise for Linux antivirus software which is provided for DoD systems and uses signatures to search for the presence o...
    Rule High Severity
    Show

  • Install the McAfee Runtime Libraries and Linux Agent

    Install the McAfee Runtime Libraries (MFErt) and Linux Agent (MFEcma).
    Rule Medium Severity
    Show

  • Harden SSH client Crypto Policy

    Crypto Policies are means of enforcing certain cryptographic settings for selected applications including OpenSSH client. To override the system wi...
    Rule Medium Severity
    Show

  • Harden SSHD Crypto Policy

    Crypto Policies are means of enforcing certain cryptographic settings for selected applications including OpenSSH server. The SSHD service is by de...
    Rule Medium Severity
    Show

  • Operating System Vendor Support and Certification

    The assurance of a vendor to provide operating system support and maintenance for their product is an important criterion to ensure product stabili...
    Group
    Show

  • The Installed Operating System Is FIPS 140-2 Certified

    To enable processing of sensitive information the operating system must provide certified cryptographic modules compliant with FIPS 140-2 standard....
    Rule High Severity
    Show

  • The Installed Operating System Is Vendor Supported

    The installed operating system must be maintained by a vendor. Red Hat Enterprise Linux is supported by Red Hat, Inc. As the Red Hat Enterprise Li...
    Rule High Severity
    Show

  • Endpoint Protection Software

    Endpoint protection security software that is not provided or supported by Red Hat can be installed to provide complementary or duplicative secur...
    Group
    Show

  • Configure Backups of User Data

    The operating system must conduct backups of user data contained in the operating system. The operating system provides utilities for automating ba...
    Rule Medium Severity
    Show

  • Install Virus Scanning Software

    Virus scanning software can be used to protect a system from penetration from computer viruses and to limit their spread through intermediate syste...
    Rule High Severity
    Show

  • Uninstall abrt-plugin-sosreport Package

    The abrt-plugin-sosreport package can be removed with the following command: 
    $ sudo yum erase abrt-plugin-sosreport
    Rule Low Severity
    Show

  • Virus Scanning Software Definitions Are Updated

    Ensure virus definition files are no older than 7 days or their last release.
    Rule Medium Severity
    Show

  • McAfee Endpoint Security for Linux (ENSL)

    McAfee Endpoint Security for Linux (ENSL) is a suite of software applications used to monitor, detect, and defend computer networks and systems.
    Group
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules