Guide to the Secure Configuration of Red Hat Enterprise Linux CoreOS 4
Rules, Groups, and Values defined within the XCCDF Benchmark
-
net.ipv6.conf.default.accept_redirects
Toggle ICMP Redirect Acceptance By DefaultValue -
net.ipv6.conf.default.accept_source_route
Trackers could be using source-routed packets to generate traffic that seems to be intra-net, but actually was created outside and has been redirec...Value -
net.ipv6.conf.default.autoconf
Enable auto configuration on IPv6 interfacesValue -
net.ipv6.conf.default.forwarding
Toggle IPv6 default ForwardingValue -
net.ipv6.conf.default.max_addresses
Maximum number of autoconfigured IPv6 addressesValue -
net.ipv6.conf.default.router_solicitations
Accept all router solicitations by default?Value -
net.ipv4.conf.all.accept_redirects
Disable ICMP Redirect AcceptanceValue -
net.ipv4.conf.all.accept_source_route
Trackers could be using source-routed packets to generate traffic that seems to be intra-net, but actually was created outside and has been redirec...Value -
Configure Accepting Router Advertisements on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ip...Rule Medium Severity -
Disable Accepting ICMP Redirects for All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Disable Accepting Router Advertisements on all IPv6 Interfaces by Default
To set the runtime status of the <code>net.ipv6.conf.default.accept_ra</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ne...Rule Medium Severity -
Disable Kernel Parameter for Accepting ICMP Redirects by Default on IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.default.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysct...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on IPv6 Interfaces by Default
To set the runtime status of the <code>net.ipv6.conf.default.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sy...Rule Medium Severity -
Limit Network-Transmitted Configuration if Using Static IPv6 Addresses
To limit the configuration information requested from other systems and accepted from the network on a system that uses statically-configured IPv6 ...Group -
Kernel Parameters Which Affect Networking
The <code>sysctl</code> utility is used to set parameters which affect the operation of the Linux kernel. Kernel parameters which affect networking...Group -
Network Related Kernel Runtime Parameters for Hosts and Routers
Certain kernel parameters should be set for systems which are acting as either hosts or routers to improve the system's ability defend against cert...Group -
net.ipv4.conf.default.arp_filter
Controls whether the ARP filter is enabled or not. 1 - Allows you to have multiple network interfaces on the same subnet, and have the ARPs for ea...Value -
net.ipv4.conf.default.arp_ignore
Control the response modes for ARP queries that resolve local target IP addresses: 0 - (default): reply for any local target IP address, configure...Value -
net.ipv4.conf.all.forwarding
Toggle IPv4 ForwardingValue
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.