Skip to content
Log In

Guide to the Secure Configuration of Oracle Linux 8

Rules, Groups, and Values defined within the XCCDF Benchmark

  • Enable cron Service

    The <code>crond</code> service is used to execute commands at preconfigured times. It is required by almost all systems to perform necessary maintenance tasks, such as notifying root of system acti...
    Rule Medium Severity
    Show

  • Verify Group Who Owns /etc/cron.allow file

    If <code>/etc/cron.allow</code> exists, it must be group-owned by <code>root</code>. To properly set the group owner of <code>/etc/cron.allow</code>, run the command: <pre>$ sudo chgrp root /etc/c...
    Rule Medium Severity
    Show

  • Verify User Who Owns /etc/cron.allow file

    If <code>/etc/cron.allow</code> exists, it must be owned by <code>root</code>. To properly set the owner of <code>/etc/cron.allow</code>, run the command: <pre>$ sudo chown root /etc/cron.allow </...
    Rule Medium Severity
    Show

  • Deprecated services

    Some deprecated software services impact the overall system security due to their behavior (leak of confidentiality in network exchange, usage as uncontrolled communication channel, risk associated...
    Group
    Show

  • Uninstall the inet-based telnet server

    The inet-based telnet daemon should be uninstalled.
    Rule High Severity
    Show

  • Uninstall the nis package

    The support for Yellowpages should not be installed unless it is required.
    Rule Low Severity
    Show

  • Uninstall the ntpdate package

    ntpdate is a historical ntp synchronization client for unixes. It sould be uninstalled.
    Rule Low Severity
    Show

  • Uninstall the ssl compliant telnet server

    The telnet daemon, even with ssl support, should be uninstalled.
    Rule High Severity
    Show

  • Uninstall the telnet server

    The telnet daemon should be uninstalled.
    Rule High Severity
    Show

  • DHCP

    The Dynamic Host Configuration Protocol (DHCP) allows systems to request and obtain an IP address and other configuration parameters from a server. <br> <br> This guide recommends configuring...
    Group
    Show

  • Configure DHCP Client if Necessary

    If DHCP must be used, then certain configuration changes can minimize the amount of information it receives and applies from the network, and thus the amount of incorrect information a rogue DHCP s...
    Group
    Show

  • Configure DHCP Server

    If the system must act as a DHCP server, the configuration information it serves should be minimized. Also, support for other protocols and DNS-updating schemes should be explicitly disabled unless...
    Group
    Show

  • Minimize Served Information

    Edit /etc/dhcp/dhcpd.conf. Examine each address range section within the file, and ensure that the following options are not defined unless there is an operational need to provide this information ...
    Rule Unknown Severity
    Show

  • Disable DHCP Server

    The DHCP server <code>dhcpd</code> is not installed or activated by default. If the software was installed and activated, but the system does not need to act as a DHCP server, it should be disabled...
    Group
    Show

  • Uninstall DHCP Server Package

    If the system does not need to act as a DHCP server, the dhcp package can be uninstalled. The <code>dhcp-server</code> package can be removed with the following command: <pre> $ sudo yum erase dhc...
    Rule Medium Severity
    Show

  • DNS Server

    Most organizations have an operational need to run at least one nameserver. However, there are many common attacks involving DNS server software, and this server software should be disabled on any ...
    Group
    Show

  • Disable DNS Server

    DNS software should be disabled on any systems which does not need to be a nameserver. Note that the BIND DNS server software is not installed on Oracle Linux 8 by default. The remainder of this se...
    Group
    Show

  • Uninstall bind Package

    The named service is provided by the bind package. The bind package can be removed with the following command: 
    $ sudo yum erase bind
    Rule Low Severity
    Show

  • Application Whitelisting Daemon

    Fapolicyd (File Access Policy Daemon) implements application whitelisting to decide file access rights. Applications that are known via a reputation source are allowed access while unknown applicat...
    Group
    Show

  • Configure Fapolicy Module to Employ a Deny-all, Permit-by-exception Policy to Allow the Execution of Authorized Software Programs.

    The Fapolicy module must be configured to employ a deny-all, permit-by-exception policy to allow the execution of authorized software programs and to prevent unauthorized software from running.
    Rule Medium Severity
    Show

Node 2

siemur/test-space

The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.

Capacity
Modules