Guide to the Secure Configuration of Fedora
Rules, Groups, and Values defined within the XCCDF Benchmark
-
Configure Accepting Default Router in Router Advertisements on All IPv6 Interfaces By Default
To set the runtime status of the <code>net.ipv6.conf.default.accept_ra_defrtr</code> kernel parameter, run the following command: <pre>$ sudo sysct...Rule Unknown Severity -
Restrict ICMP Message Types
In <code>/etc/sysconfig/iptables</code>, the accepted ICMP messages types can be restricted. To accept only ICMP echo reply, destination unreachabl...Group -
Log and Drop Packets with Suspicious Source Addresses
Packets with non-routable source addresses should be rejected, as they may indicate spoofing. Because the modified policy will reject non-matching ...Group -
IPv6
The system includes support for Internet Protocol version 6. A major and often-mentioned improvement over IPv4 is its enormous increase in the numb...Group -
Disable Support for IPv6 Unless Needed
Despite configuration that suggests support for IPv6 has been disabled, link-local IPv6 address auto-configuration occurs even when only an IPv4 ad...Group -
Ensure IPv6 is disabled through kernel boot parameter
To disable IPv6 protocol support in the Linux kernel, add the argument <code>ipv6.disable=1</code> to the default GRUB2 command line for the Linux ...Rule Low Severity -
Disable IPv6 Networking Support Automatic Loading
To prevent the IPv6 kernel module (<code>ipv6</code>) from binding to the IPv6 networking stack, add the following line to <code>/etc/modprobe.d/di...Rule Medium Severity -
Disable Interface Usage of IPv6
To disable interface usage of IPv6, add or correct the following lines in <code>/etc/sysconfig/network</code>: <pre>NETWORKING_IPV6=no IPV6INIT=no<...Rule Unknown Severity -
Disable Support for RPC IPv6
RPC services for NFSv4 try to load transport modules for <code>udp6</code> and <code>tcp6</code> by default, even if IPv6 has been disabled in <cod...Rule Unknown Severity -
Disable IPv6 Addressing on All IPv6 Interfaces
To disable support for (<code>ipv6</code>) addressing on all interface add the following line to <code>/etc/sysctl.d/ipv6.conf</code> (or another f...Rule Medium Severity -
net.ipv6.conf.all.accept_ra_pinfo
Accept prefix information in router advertisements?Value -
net.ipv6.conf.all.accept_ra_rtr_pref
Accept router preference in router advertisements?Value -
Configure Accepting Default Router in Router Advertisements on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_ra_defrtr</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Unknown Severity -
Configure Accepting Prefix Information in Router Advertisements on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_ra_pinfo</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ...Rule Unknown Severity -
Configure Accepting Router Preference in Router Advertisements on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_ra_rtr_pref</code> kernel parameter, run the following command: <pre>$ sudo sysctl ...Rule Unknown Severity -
Disable Accepting ICMP Redirects for All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_redirects</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w...Rule Medium Severity -
Disable Kernel Parameter for Accepting Source-Routed Packets on all IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.accept_source_route</code> kernel parameter, run the following command: <pre>$ sudo sysctl...Rule Medium Severity -
Configure Auto Configuration on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.autoconf</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.ipv...Rule Unknown Severity -
Disable Kernel Parameter for IPv6 Forwarding
To set the runtime status of the <code>net.ipv6.conf.all.forwarding</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w net.i...Rule Medium Severity -
Configure Maximum Number of Autoconfigured Addresses on All IPv6 Interfaces
To set the runtime status of the <code>net.ipv6.conf.all.max_addresses</code> kernel parameter, run the following command: <pre>$ sudo sysctl -w ne...Rule Unknown Severity
Node 2
The content of the drawer really is up to you. It could have form fields, definition lists, text lists, labels, charts, progress bars, etc. Spacing recommendation is 24px margins. You can put tabs in here, and can also make the drawer scrollable.